Hi all
92 Jackaroo 3.1L Diesel
Had to replace the Clutch
Removed gearbox and brought new clutch
noticed rear main seal was leaking, as a new seal was only $8 decided to replace
now the first time i put it in, it leaked badly
so, gearbox and everything out again,
bulit a cup which uses the bolts to press the seal in
but my question, how far back does the new seal have to sit ?
i was worried i was going to push the seal too far into the slot
can this happen ? or will i know when i have pressed it in far enough ?
ill take a photo of the tool we designed, its similar to the isuzu tool thats worth $300 we built it for $10
But we are not sure how much pressure we should put on the rubber to get it into the slot and over the inner tab