Further to this thread http://forum.australia4wd.com/index.php?/topic/26155-engine-check-light-problem/
I thought I would start my own. I have now been able to upload a low grade video, but you still get the idea.
I took the ute with parts to a national service centre for them to do the timing belt service.
It has been back about 7 times and due to go back again. The service centre is going to give it a good going over (hopefully) to see whether they can nut out the problem.
Any ideas would be appreciated. Apart from running rough like this video every other day
I generally notice that with the clutch depressed it dips below 800rpm, say 600rpm, and floats around 750-850.
There is a considerable lack of power after starting sometimes I notice no choke. The only codes that it has thrown is the P0172 P0175 once.
Oh the MAF and TPS sensor check out ok. I currently have the TPS reading on the scan gauge at the moment and there seems to be no issue.
I thought I would start my own. I have now been able to upload a low grade video, but you still get the idea.
I took the ute with parts to a national service centre for them to do the timing belt service.
It has been back about 7 times and due to go back again. The service centre is going to give it a good going over (hopefully) to see whether they can nut out the problem.
Any ideas would be appreciated. Apart from running rough like this video every other day
I generally notice that with the clutch depressed it dips below 800rpm, say 600rpm, and floats around 750-850.
There is a considerable lack of power after starting sometimes I notice no choke. The only codes that it has thrown is the P0172 P0175 once.
Oh the MAF and TPS sensor check out ok. I currently have the TPS reading on the scan gauge at the moment and there seems to be no issue.