RA LT Wheel Centre Caps
On of my center caps got pinched. Where can I get a replacement that won't cost an armand a leg?
View ArticleVGT turbo on 4JH1 - anyone done it?
Hey guys, has anyone tried fitting the vgt turbo from the 4jj1 onto their 4jh1? At a glance it looks like the turbine inlet flanges are identical, and that the housings will only need to be clocked...
View Articleengine check light question
Hi everyone, I had a flick through the other posts but didnt find anything on my question. Yesterday while driving my 07 Rodeo diesel the engine light came on it dropped in power we pulled over turned...
View ArticleEmail from Ramin Auto Parts, U.A.E.
Hi to all, I received an email from Ramin Auto Parts about a week ago that I found a bit unusual as I had not contacted them recently, ??? Not being the greatest computer whizz, and concerned...
View Article2004 ra rodeo sports bar
Can anyone tell me if sports bars from different dual cabs can fit a 2004 rodeo. Or does it have to be a holden one. Can find lots of hilux and triton ones.
View ArticleShift on the fly lubrication
Can someone tell me if the shift on the fly on a 2010 Dmax is lubricated by the front diff. Reason being the manual states to check the shift on fly and to up oil if necessary, I just replaced the...
View Article2" body kit
has any one done this and what do you think of it http://www.ebay.com.au/itm/Holden-Frontera-body-lift-4wd-2-4x4-/260828040559?pt=AU_Car_Parts_Accessories&hash=item3cba900d6f thinking of doing it...
View ArticleClik here to view.
Bloody Fronteras...Time to give up
Lowlifes are quoting a dirty torque converter as evidence of abuse 2nd time in 5000ks since a full recondition costing over $3200 bucks its has blown up and apparently the wear seen in pick 3 CANT...
View Article3.5 V6 jackaroo overheating but not loosing any water
Hi guysI have a 99 Jackaroo 3.5L v6 that has a strange overheating problem. Firstly i will explain what i have already checked, thermostat has been replaced, fan clutch has been checked, there is no...
View ArticleClik here to view.
something else to check when doing sleeve seals
SOMETHING TO WATCH OUT FOR WHEN REMOVING SLEEVESMake sure to check when removing sleeves, that there is some sort good resistance when pulling them out, if there's no resistance, and they come out with...
View ArticleBody lift
Has anyone had any issues with turbo hitting steering shaft after a 1 inch body lift and only on takeoff in -st gear?
View ArticleTumut rally this saturday
Jackaroo (and me) as a service crew, drive in at spectators points to take a look of the race and at service area for a cup of coffee and chat You're welcome! Sergey
View Articlegot 300 000 on the clock.
about 80 000 done by me. Decpite of all issues it was a good decision to buy a Jackaroo. Hope to doble up this clock reading :-) Have a nice day Sergey
View Article2002 Jackaroo SE 3.5l V6 - double din stereo and long range fuel tank questions
Hi guys, I'm getting possibly the tidiest 2002 Jackaroo on the road! It's my old mans and has done just 70000km's. My first 4x4 finally after having a 4x2 Hilux Single Cab. Just a couple of questions...
View ArticleOil Rail Pressure Sensor Valve Rebuilding for 4JX1 engine.
Hello, A common problem i have experienced over 3 models with this engine whilst in my ownership has been this part that caused erratic running after a while (hesitation in acceleration and lumpy...
View Articlecoil spacers
2001 Frontera I recall reading on here Toyota spacers fit but I can't find any reference.Are they front or rear and which model Toyota?Thanks for any help.
View ArticleAnother 4JX1 problem - can't pinpoint the fault
Hey guys, need help. Long story so here goes: 2000 MODEL Jackaroo 3.0L Turbo Diesel Automatic 177,000kms 10 days ago I parked the car up to go away. Everything was fine. Came back and the car...
View ArticleClik here to view.
Att: Non Calmini lifted Frontera owners
I have been wanting a Calmini kit for about 4 years now, but budget has always gone elsewhere (who'd be a home owner!). Anyway, plan B has been to try and source the bent rear upper control arms so...
View Article3.5 fuel trim figures
Hi all. Just wondering if anybody that has the elm 327 wifi has been able to get short and long fuel trims for bank 2 to work. Ive got bank 1 bouncing between -6.6 up to +11.%. Ive replaced 02 sensor....
View ArticleElectric window repair
Hi, Have just discovered the rear PS window doesnt work. Can hear a click when the switch is operated. I thought I might have read a thread somewhere on the repair procedure, couldnt find it though....
View Article